DuPont™ Cyrel DPI ( 1,14 | 1,7 )

At your request we will make photopolymer plates (flexo) on the DuPont ™ Cyrel DPI (1,14 | 1,7) - the material is always available in the Moscow, Yekaterinburg, Novosibirsk, Nizhny Novgorod and Kiev

Cyrel DPI - digital plate for high quality printing in various packaging segments, designed specifically to meet the needs of modern flexo printing.

Areas of use

• Flexible packaging
• Labels
• Folding cartons
• Boxes for beverages

product Features

• Excellent transmission gradation
• Clear strokes
• Low dot gain halftone dots
• High resolution of exposure gives a better play
• The relief image is clean and clear
• High resistance to ozone and white light allows you to store the products for a long time

Compatible with printing inks and solvents

Forms Cyrel DPI provide excellent compatibility with solvent-based inks and water-based paints.

Description of the manufacturing process

Expose the plate through the back to create a "cap" and maximize sensitivity. Back exposure varies according to relief required. Remove the protective sheet and record the image with the Cyrel Digital Imager (CDI). Spend the main exhibition. Process the plate in the Cyrel solvent processor to remove unexposed polymer. Spend finisher to remove residual surface tackiness.

Mounting form

To install the recommended forms of Cyrel DPI device mounting photopolymer plates Cyrel Microflex. Double-sided adhesive tape should be applied to the printing cylinder or sleeve in a form for easier and precise assembly. The polyester base will maintain accurate register even for large forms.

Storage of raw materials

Неэкспонированные пластины необходимо хранить в прохладном месте(4-32°C), вдали от прямых источников тепла. Контроль влажности не требуется. В упаковках Cyrel* DPI имеются прокладки из вспененного материала, обеспечивающие максимальную защиту форм при транспортировке и хранении. Коробки с пластинами хранятся в горизонтальном положении. Пластины не должны подвергаться воздействию прямого солнечного или яркого белого света. Избегать воздействия озона.

Working with plates

Photopolymer plates Cyrel DPI should be handled under UV free light; fluorescent bulbs should be covered with a special film that protects from UV radiation.

Storage of printed forms

After printing, plates should be thoroughly cleaned with compatible solvent. They can be stored on cylinders, sleeves or demounted and stored flat.

TECHNICAL DATA
Cyrel® DPI 45 Thickness 1.14 mm Cyrel® DPI 67 Thickness 1,70 mm
Stiffness 76 Shore A 70 Shore A
Reproduction gradations 1 - 98% 60 lines / cm 1 - 98% 60 lines / cm
The minimum line width 0,050 mm 0,050 mm
The minimum diameter of the point 0,20 mm 0,20 mm
The depth of relief 0,60 mm 0,70 mm

This technical information is provided free of charge and is based on data, which DuPont believes to be reliable. The information is intended for specialists and can be used at their discretion. The use of this information means that all those using it will satisfy themselves that their particular conditions of use present no health and safety. Since such conditions can not be controlled, DuPont does not give any guarantee and does not accept any liability regarding the use of this information. This information can not be used as a license or as a recommendation to infringe any patents.