DuPont™ Cyrel DPU ( 1,14 | 1.7 )

At your request we will make photopolymer plates (flexo) on the DuPont™ Cyrel DPU ( 1,14 | 1.7 ) - the material is always available in the Moscow, Yekaterinburg, Novosibirsk, Nizhny Novgorod and Kiev

Cyrel DPU - plate, which can be used in combination with any printing inks and substrates. It provides an excellent raster printing works, as well as stroke and dies.

Areas of use

• Flexible packaging
• Labels
• Bags Packages
• Folding cartons
• Packaging for beverages



product Features

• Easy to use on a printing press
• Excellent ink transfer printing provides great uniformity
• High resolution exposure provides higher print quality
• The relief image is clean and clear
• High resistance to ozone and white light allows you to store the products for a long time

Compatible with printing inks and solvents

Forms Cyrel® DPU provide excellent compatibility with solvent-based inks, UV inks and water based paints.

Description of the manufacturing process

Expose the plate through the back to create a "cap" and maximize sensitivity. Back exposure varies according to relief required. Remove the protective sheet and record the image with the Cyrel® Digital Imager (CDI). Spend the main exhibition. Process the plate in the Cyrel® solvent processor to remove unexposed polymer. Spend finisher to remove residual surface tackiness.

Mounting form

To install the recommended forms Cyrel® DPU device mounting photopolymer plates Cyrel® Microflex. Double-sided adhesive tape should be applied to the printing cylinder or sleeve in a form for easier and precise assembly. The polyester base will maintain accurate register even for large shapes.

Storage of raw materials

Unexposed plates should be stored in a cool place (4-32 ° C), away from direct heat sources. Humidity control is not required. Packages are Cyrel® DPU is foam interleaved to provide maximum protection of the plate during transportation and storage. Plates should be stored in a horizontal position. Plates should not be exposed to direct sunlight or bright white light. Avoid exposure to ozone.

Working with plates

Photopolymer Cyrel® DPU plates should be handled under UV free light; fluorescent bulbs should be covered with a special film that protects from UV radiation.

Storage of printed forms

After printing, plates should be thoroughly cleaned with compatible solvent. They can be stored on cylinders, sleeves or demounted and stored flat.

TECHNICAL DATA
Cyrel® DPU 100 Thickness 1,14 mm Cyrel® DPU 112 Thickness 1,70 mm
Stiffness 76 Shore A 67 Shore A
Reproduction gradations 1 - 98% 60 lines / cm 1 - 98% 60 lines / cm
The minimum line width 0,050 mm 0,050 mm
The minimum diameter of the point 0,20 mm 0,20 mm
The depth of relief 0,60 mm 0,70 mm

This technical information is provided free of charge and is based on data, which DuPont believes to be reliable. The information is intended for specialists and can be used at their discretion. The use of this information means that all those using it will satisfy themselves that their particular conditions of use present no health and safety. Since such conditions can not be controlled, DuPont does not give any guarantee and does not accept any liability regarding the use of this information. This information can not be used as a license or as a recommendation to infringe any patents.